Inconel/Teflon/Pvdf Finish Thompson Chemical Pump

Designed for free-flowing liquids up to 2,000 cPs viscosity and 1.8 specific gravity. 40″ long pump tube fits 2″ bung opening. Seal-less design has 30 minute run-dry capability without damage. Features double suction impeller. Polypropylene and Kynar® pumps have convenient variable orifice discharge fitting. Totally Enclosed Fan Cooled Motor (TEFC) is designed for corrosive environments. 1/2 hp and 1 hp, double insulated, 110 volt, 50/60 Hz, singlephase. Handle has built-in switch, thermal overload protection with manual reset, 12′ cord with plug. 1 hp motor includes speed regulator for precise adjustment of fluid flow. Open
Drip-Proof Motor (ODP) is designed for non-corrosive environments. 1/2 hp, 110 volt, 50/60 Hz, single-phase. Handle has built-in switch, thermal overload protection with manual reset, 12′ cord with plug. Explosion-Proof Motor (EP) is 1/10 hp, double insulated, 110 volt, 50/60 Hz, single-phase, with 12′ three-wire cord without plug. CSA-Listed for Class I, Division I, Group D. Air Motor (Air) develops 1/2 hp, uses 17 – 25 CFM @ 50 – 80 psi. Supplied with regulator valve and muffler. All pumps in this series have a 1″ hose barb. Note: When pumping flammables, use only a stainless steel pump tube with an explosion
proof motor and be sure to use a static protection hose kit found in Accessories for Finish Thompson Pumps. Container will also require grounding. See Bonding and Grounding Wires.

Shown 8PFS-E1

Features:

Internals: Stainless/Teflon®/Tefzel
Max. GPM: 40
Max. Temp.: 220ºF
Max.Viscosity: 500 cps
Motor: TEFC
Pump Tube: Stainless
Weight: 26 lbs.
 

.