Description
AC/DC Hall effect voltage transducer has measuring range of AC/DC 100V/500V/1000V/2000V/3000V to 4000V.
Specification:
| Model | ATO-WBV023YB08-SS / ATO-WBV023YB08-DD |
| Shipping weight | 2kg |
| Measuring range of input voltage * | AC/DC 0-100V ~ 0-4000V |
| Working range | AC/DC 0-200V ~ 0-6000V |
| Turns ratio of coil * | 20000:1000 |
| Secondary coil impedance | 55Ω |
| Zero current offset | ≤±0.2mA (Ip=0) |
| Output signal * | AC/DC 50mA |
| Power supply * | DC ±12V, ±15V, ±24V |
| Accuracy | 0.5%F.S. |
| Linearity | ≤0.1% |
| Load impedance | 80Ω |
| Response time | ≤200μs |
| Temperature drift of current offset | ≤±0.6mA (-40~+85℃) |
| Power consumption current | 10mA+IM (measuring current) |
| Isolation features | Isolation between input and output, output terminals provides power supply |
| Isolation voltage | Between the primary and secondary circuit: RMS 12kV, 50Hz, 1min |
| Work temperature | -40~+85℃ |
| Storage temperature | -55~+125℃ |
| Frequency band | DC ~5kHz |
| Mean time between failures | ＞50000h |
| Housing material | PBT |
| Wiring | Terminal connection |
| Installation | Screw fixation |
Hall effect voltage transducer AC/DC 100V to 4000V dimensional drawing (unit: mm):
Hall effect voltage transducer AC/DC 100V to 4000V wiring diagram:
Tips: Attentions for using Hall effect voltage sensor
- When using the Hall effect voltage sensor, connect the secondary power supply first, and then connect the primary voltage.
- When measuring the voltage, the measured voltage should be connected in series with the current-limiting resistor. After the primary current specified by the voltage sensor is obtained, the primary side terminal of the voltage sensor is connected.
- The best accuracy of the voltage sensor is measured at the rated value. When the measured current is lower than the rated value, in order to obtain better accuracy, the primary side can use multiple turns, namely: Ip * Np = rated ampere turns.
Reviews
There are no reviews yet.